When it’s bitter and too much cold outside then, nothing strikes the glowing crackle and light of wood fire from the inside fireplace. Supporting your furnace frequently will guarantee that it functions in the most reliable, most effective practice desirable.

Safety

Normal hydronic safety valves are to be fitted as well as suitable expansion capability. Therefore a wood log safety flush valve, a 3 BAR pressure relief valve [PRV] and a quality air dirt remover.

Routine cleaning should be continued

You must brush out your KK Series gasification boiler. Do this AFTER moving the heat exchanger handle back & forth a few times. Dust in the galleries will drop into the lower chamber. Brush & vacuum the two chambers.

Check the quality of the wood

Hardwood serves as the most fitting fuel for your wood hydronic boiler Such as ash, oak, beech, and maple; these hardwoods require better treatment before their use. Managing the hardwood will need you to slice the wood and later divide and concentrate it throughout a year. In the end, you can access the quality of the woods, which you are going to burn. Also, mind that you should have a proper shed to keep the woods.

Servicing of your boiler

Servicing your boiler annually will ensure it keeps running optimally for as long as possible. Read the user guide for details, if unsure ring Kroll on 1800 805 243. As a rule, it is good to service your boiler in September or October so that it is ready for heavy use during autumn and winter.

Bleed the radiators

After you switch to the boiler, make sure you keep them running. Radiators heat up very immediately; this happens just because of the air run in radiators. To make sure to touch the radiator, you will also see that the bottom is hot.

You can resolve the issue with these consequent steps:-

  • Take a rag and the key of the radiator.

  • Wrap the carpeting, and utilize a container in fact if there is a leakage.

  • valve key utilization and

  • Using the valve key, implant, and apply smoothly counter-clockwise.

  • Mind the hissing sound, which shows the air escape from the radiator.

  • clean the extra water

  • Transform the radiator key to secure the valve

  • To verify whether the bottom of the radiator is hot or not.